Questions & Answers for: Gateway auto command Computers & Internet

auto-learning command, it didn't work. So, I tried to run the batter completely down and re-charge it. Neither solution worked. So I tried the smart battery auto-learning command again and it has been

...command prompt; start menu, run, type cmd, type chkdsk, press enter. After check disk is done type chkdsk /r and press enter. press y (yes) and restart PC and let it auto check for repair of any ...

command You have to boot from Xp disc and press R to repair and run following commands fixmbr fixboot chkdsk /p chkdsk /r bootcfg /rebuild Hi I am vortash I think this is a farily easy one .. when you

...command prompt or run(general tab - start up type should be auto and service status should started - then first,second and subsequent failure should restart the service under recovery tab - check ur ...

auto assign. Do not manual input an ip address. You can see if the wireless card is pulling an IP address by going to Start, Run and type command or cmd then in the black dos window type ipconfig /all

...auto-shut-down, and repeats this process until I manually shut it down. I need a way to get in from command prompt or something so I can select factory setting???? alt f10 no good, f1 no good, f11 no ...