Questions & Answers for: change ignitor

my dryer is not heating up, just recently changes the ignitor just recently changed the ignitor on the dryer (gas) and it was working fine, a few days ago it stoped heating again, ignitor was just ...

ignitor wire, it should draw above 3AMPs, if not then you have problem with the oven ignitor and not the safety valve. we hardly change the safety valve, I'll try to change the ignitor first. Have fun

...change the ignitor. If there is no viltage to the ignitor, check continuity on the thermostats and the fuse that are located on the blower housing. Also test the sensor located on the burner. I hope ...

...ignitor, still no change--broiler won't light while ignitor glows. He left telling me that we needed to replace the control unit. Before spending hundreds of dollars, is he correct? PS, they wanted ...

ignitor will not glow I changed the ignitor and the two electrical parts on the gas valve. Still can't get the ignitor to light. IF MOTOR RUNIN AND NOT HEAT YOU NEED CHEK: 1-THERMAL FUSE. 2-SENSOR ...

...fine yesterday, today no ignitor. Worked fine yesterday, today not ignitor. No spark no clicking. I changed the battery and still nothing. Any advise? Check your ignitor wires for broken or ...

...should lite within 40 seconds,if it doesn't change out the ignitor,even if it glows that doesn't mean the ignitor is still good change it out.let me know what you find and next time send model ...

...down this is what happens,it takes longer and longer for it to ignite the flame and i've seen some ignitors burn a hole in the tub,change out the ignitor and you'll be all set,part number

...sending 24 volts to gas valve. If it is but no gas, bad gas valve. If not, bad ignitor or bad PC board. I would change out the ignitor first since it is a wear item as well as the cheapest

ignitor changes in resistance as it gets hotter. This change in resistance is needed toopen the safety valve. Yall might think the ignitor is fine because yall can see it working. But if it is weak it