Questions & Answers for: cutter fault

...the cutter in the printer properties. Position fault is that it does not detect the label, must be press the FEED key or to calibrate, press the FEED key for 5 seconds to calibrate the sensor

...cutter 40 Am, In test it did cut up to 10 mm easily but now some time it is not cutting 10 mm mild steel. It is still ok on 6mm steel with full current. I did replace electrode and tip.I remember in ...

...Cutter Fault When I power the printer on it displays cutter fault. If I go into the setup menu and go to Printer Options and Cutter, it breifly flashes Not Installed and then displays Enabled. If I ...

...The auto cutter no longer works and the receipt paper does not advance fully. You will need to take the printer in for a service. The cutter is Jammed and that causes the fault on the paper

...cutter just flashes fault everytime you try and use it. could it be the ground or would it be the electrod check the main lead to the torch,if there is a cut or any hole in the rubber coating it will ...

advice Check compressed air pressure is in limits otherwise unit will cut out. Try adjusting the pressure up. also make sure the supply pressure is correct as it may not be your plasma cutter at fault

...cutter is on, also, it is printing double lines Fault: Double line & paper is not cutting.>Check encoder strip, any damage or dirty?>Clean encoder strip, replace it..Reason why its not ...

Fault light is on all the time. Is there a fuse ? Hi: No there is no fuse for the fault light. Fault light it's on only when: 1) Voltage is wrong or not enough. 2) Overheated machine and needs to ...

has cup fault Check connections on holder and at the main unit.  blow out the unit with air to eliminate conductive dust as being a problem.  Also make sure cup seating area is clean.

...cutter would not start after lots of heavy use.NOW AFTER ON A REALISTIC AVERAGE OF USAGE SINCE SERVICE:45 MINUTES MAX USAGE SPREAD OVER A 6 MONTH PERIOD- I HAVE THE EXACT SAME PROBLEM WHERE IT RUNS ...