Questions & Answers for: Sharp developer unit change Computers & Internet

...developer unit housing just above the TD slot. carefully remove the DV unit without tipping or you will spill out the existing DV. Then you can pull out the drum unit. There may be a green screw on ...

...developer unit along with the toner. It is easy to replace. Slide out the developer unit with the toner hopper still attached by sliding the a white spring loaded stopping mechanism so you can slide ...

...the blue screw to release the developing unit, open the side cover and pull the developing unit, check the gears at the rear of the developing unit and replace if one spoiled and change the ...

...developer, changed drum unit, everything worked fine, but I've got an error message, the toner/developer lamp blinking, and I tried the C exposure C exposure 24 Start 06 Start method, no success... ...

...developer unit and use the plastic gear on the backside of the unit to spin the magnetic rod until all of the developer has been removed (be careful not to scratch the surface of this rod, as it's ...

...developer unit from another machine because it was faulty, maybe it has run out of toner? You have to change the Developer in the developing unit. code is: AR271D This procedure must be done by a ...

...dump the developer in my sharp ar-5520s mfp if you want change developer,pullout toner cartridge open blue screw,remove developer unit ,open 3 screws,remove black cover remove old developer and add ...

...developer unit chip, you may have to replace the chip on the developer unit or the developer unit itself. F2 problem is you have to change the toner,maybe you had put a wrong toner. check if the ...

My Sharp copier cannot get out standby mode and is flashing the developer indicator. install the developer unit , or change developer inside the unit, and reset using Sim code 42-01

MY SHARP MX B201D PHOTOCOPIER SHOWS "CHANGE DEVELOPER UNIT". WHAT SHOULD I DO? Change the developer unit