Question about SyncMaster 710N 17" LCD Monitor
...fluorescent light bulb I have a SyncMaster 710N from 2005, and late last year it began to flicker like a dying fluorescent light bulb. I've tried changeing the refresh rate, unplugging it and ...
...light went, i changed the lcd cable thinking it could be this, but apparantly not any help greatful, Thanks in advance The Backlight is a separate module actually called "FL Inverter" Its same logic ...
I have a lot of 4' fluorescent lights that are I have a lot of 25 year old 4' fluorescent lights that are built into the ceiling with the top of the fixtures in the attic. They work fine in the winter
Question about R01-PR180-1LI Decora 180 Degree PIR Motion Switch Ivory
...occupancy sensor manual, and the PR180 sell-sheet, and these documents say for incandescent and fluorescent (rapid-start magnetic ballast only). -Compact fluorescent are supposed to have a ...
...fluorescent tubes as a light source. These are gradually being replaced with LEDs so this problem won't exist in a few more years. The tubes are miniature versions of fluorescent lights we use daily ...
...Lightolier Dimmer switch, which was recommended by the manufacturer (Robern Cabinets) to power the fluorescent lighting that was included. I have installed and wired per the directions. The ...
...fluorescent fixtures but does not. When I turn the light off the switch illuminates for a second or two and goes out. i've tried new switches - same problem. Does this have something to do with the ...
...fluorescent lamps. If the background light comes on and then goes off after a second it's probably a fluorescent tube problem and not worth fixing. Capacitors are easy and cheap to replace. Bad ...
Question about DVF-103P-277 Diva Fluorescent Dimmer, Single-Pole / 3-Way, 6 Amps
...light dimmer?Does the dimmer feel warm to touch? or hot?What does the dimmer control? Incandescent? Fluorescent?How many total watts are being dimmed?Is this a new dimmer or old dimmer that started ...
...light bulbs). A compact fluorescent or some other lighting may blow the switches. If your lights are led they may not have sufficient resistance so that the dimmer knows that you have any lighting at ...
Usually answered in minutes!
