Question about SyncMaster 710N 17" LCD Monitor
Flickeing like a dying fluorescent light bulb I have a SyncMaster 710N from 2005, and late last year it began to flicker like a dying fluorescent light bulb. I've tried changeing the refresh rate, ...
Problems The back light has gone, But when shinning a light on it, it goes funny get loads of different coloured lines going down the back, before the back light went, i changed the lcd cable thinking
...fluorescent lights that are I have a lot of 25 year old 4' fluorescent lights that are built into the ceiling with the top of the fixtures in the attic. They work fine in the winter but in the summer ...
Question about R01-PR180-1LI Decora 180 Degree PIR Motion Switch Ivory
...lights stop flickering and humming. Full brightness as well. -Replace the compact florescent bulbs with regular incandescent bulbs and see if problem continues. -Lighting controls are made for ...
fluorescent lights we use daily and have ratings of under 10,000 hours and can fail in far fewer; typically about half of that. The inverters that supply the high voltage for them can fail at any time
...Lightolier Dimmer switch, which was recommended by the manufacturer (Robern Cabinets) to power the fluorescent lighting that was included. I have installed and wired per the directions. The ...
I installed a Decora white illuminated wall switch to control a fluorescent bathroom fixture; the switch is advertised as working with fluorescent fixtures but does not. When I turn the light off the ...
...problems with Viewsonics are bad capacitors on the power supply board and bad fluorescent lamps. If the background light comes on and then goes off after a second it's probably a fluorescent tube ...
Question about DVF-103P-277 Diva Fluorescent Dimmer, Single-Pole / 3-Way, 6 Amps
...LIGHTS START BLINKING Which dimmer do you have. So I can look up the manual.Are you using a fan dimmer, or light dimmer?Does the dimmer feel warm to touch? or hot?What does the dimmer control? ...
...fluorescent or some other lighting may blow the switches. If your lights are led they may not have sufficient resistance so that the dimmer knows that you have any lighting at all. Fluorescent ...
Usually answered in minutes!
19,136 Questions
12,215 Questions
7,310 Questions
7,276 Questions
5,470 Questions