Questions & Answers for: hand drill

...puty my hands on the chuck held it , started the drill and the head does not seem to turn.? either you have low battery or the gear is stripped. the drill should have enough torque to break your

drill dd991 14.4 volt I need to replace the chuck are the treads inside it left or right handed? The chuck retaining screw are left handed and the chuck itself is standard right hand. Let me know if I

hand and place over the drill part that moves when u squeeze the trigger. OK..Remember this! Right-Tight...Left Loose. When drill moves to the right...It is tightening (the bit, the screw your driving

I need to replace the 1/2" chuck on my Dewalt dw124 right angl drill. there is a left hand screw in the chuck that holds it in take it out then unscrew the chuck right hand thread

...hand and pulling trigger (GENTLY or you will shave off skin!) - put drill in forward or reverse mode and pull trigger to inser or remove screw / drill hole. ensure that battery is charged on cordless ...

...drill with one hand and rotate the end the bit is inserted into counter-clockwise if the bit end is pointed towards you to loosen the arms and release the bit. If it is an older drill it may have a ...

...drill from the back. Some drills have a locking chuck and only need to turn with one hand. Other drills don't have this option and use a 2 piece chuck. If it looks like there are 2 parts to the ...

...in a firm grasp as your hand around a pipe and hold tight,run drill in reverse and that should loosen the chuck and the bit. If its to tight for your hand get a pair of channel locks and hold

...hand and hold the drill with your right hand. Turn the chuck with your left hand quickly, this should release the drill as well. When you need power with comfort, you should turn your head towards ...

...hand drill, eggbeater type. Where can I get a manual? This is a hand-cranked drill, with what looks to be rosewood handles. The hand wheel is spoked not solid which I think puts the vintage somewhere ...