Questions & Answers for: IBM initialisation failed Computers & Internet

IBM RISC 6000 Error code The box will not boot and I'm getting a flashing 888-103-409-094. When I boot into maintanence mode I get several FRU numbers to include for the CPU. I'm unable to locate this

When I start my computer I get an error message: Disk I/O error. After starting the computer I receive the follow message: Disk I/O error Replace the disk, and then press any key The hard drive in ...

thinkpad i1400-2621-480 bios does not recognise my new hard drive my old trvelstar hard drive had died .so i took out the drive anrd replaced with initialised and( formatted by adapter on my desktop ...

failed 11 Short Beeps The external cache is faulty 1 Long, 3 Short Beeps Memory Problems 1 Long, 8 Short Beeps Video Card Problems Phoenix BIOS Beep Codes Note - Phoenix BIOS emits three sets of beeps

my pc is failing to pik directX 9.0 graphics my pc is failing to pick directX 9.0 graphics accelerator.It is saying on desplay that Graphics Accelerator un available. What should i do to correct this?

ERROR 0175: Bad CRC1, stop POST task message Been using my IBM a30 laptop for some months but was surprised to get this error when i tried putting it on this message pops up ERROR 0175:BAD CRC1 STOP ...

ServerRAID-6i Logical drv =1, Others=0 Firmware7.12.13,Status OK Warning:1 Logical drive(s) Offline Warning:1 Online drive(s) defunct HI, It appears you may have a failed "physical" drive in your Raid

When i start my IBM it shows me a message: a disk read error occurred! what should i do? You should both run disk diagnostics on the system and get a replacement drive. The drive is failing or has ...

...initialisation failed on IBM X3400 server type 7975 what we should do You need to figure out which BIOS is corrupted. If its the RAID controller BIOS your card may be bad if its the Motherboard BIOS ...

...initialisation, get range failed. Then the manual says: "Isolating a library controller card versus accessor enclosure problem" on page 7-11 But I guess you better look it up yourself. If you don't ...