Questions & Answers for: Behringer jack panel Computers & Internet

...and the bottom (four screws each), all the knobs (50 of them), undo the nuts on the various 1/4" jacks (14), then finally remove the screws mounting the single circuit board (13). The power jack ...

...of tab for the knob... It is a lot of work removing all the knobs, all the nuts on the 1/4 inch jacks, and screws, including those for the XLR

...jack. This prevents hum. You may be able to purchase premade cables but I made my own. The XLR jacks are plugged into the left and right balanced or unbalanced Main output jacks of the mixer. On your ...

panel AND all the 1/4 inch jack hardware has to be removed. Remove EVERYTHING else BEFORE removing the small screws... It is a LOT of work, although this mixer is small compared to some! Be careful to

...panel labeled 'Main Output' Left and Right, if your amp has XLR inputs you should use these. Otherwise there are two jack sockets labeled 'Main Out'. This is a complex desk with a lot ...

...can still use the power amp of the GMX212... On the back panel, the "SLAVE IN" inputs are 2 mono jacks, left and right, for stereo input. Plug in the output of an effects pedal or a preamp here

...a balanced cable with the appropriate connectors from the OUTPUT RIGHT or LEFT jacks on the Feedback Destroyer's back panel to the main amplifier INPUT jack or amplified house speaker INPUT

...and drilled to accomodate the jack will work if the old panel is thin enough.  If not, one chunk can be used and then that patch of a single clad board gets attached to the panel with

...jack labeled "L" found on the "Main Out" panel. Connect another cable to the right channel jack with the "R" label. Connect the opposite end of each cable to the matching left and right inputs on you ...

...panel, only the right ch. signal level light is brinking. if this is true on all right channel inputs and not just one you tried , then id look at your effects loop send jack , there is a tiny switch ...