Questions & Answers for: mcu

...error Communication between the Central Control Unit (CCU) and the Motor Control Unit (MCU) cannot be sent correctly. Potential Causes ? Check Wire Harness connections to the MCU, the ...

...harness issue. Communication between the Central Control Unit (CCU) and the Motor Control Unit (MCU) cannot be sent correctly. Possible Causes / Procedure 1. Unplug washer or disconnect power. 2. ...

...error code(F-11) Communication between the Central Control Unit (CCU) and the Motor Control Unit (MCU) cannot be sent correctly. Possible Causes / Procedure 1. Unplug washer or disconnect power. 2. ...

...Causes/Procedure 1. Unplug washer or disconnect power. 2. Check wire harness connections to the MCU, the motor, and Central Control Unit (CCU). - Check connections of the CCU board within the ...

...ROS Start-of-Scan (C) signals exceeds the specified value. Procedure +5VDC is measured between the MCU PWB P/J401-A1 (+) and ground (-). Yes No Unanswered Replace the MCU PWB ( PL 13.1). Refer to ...

...up 98% of the time on high spin; 70% of time on medium & low spin. Checked conections between MCU & CCU. Should I buy a new MCU or a new washer? No do the following: Check wire harness ...

45682 error code f 15 Error F15 Motor Control Unit (MCU) Error If the MCU detects multiple resets or errors during a wash cycle it will go into this error mode. Potential Causes - Check wiring harness

error code f15 Error F15 Motor Control Unit (MCU) Error If the MCU detects multiple resets or errors during a wash cycle it will go into this error mode. Potential Causes - Check wiring harness ...

Error F28 The F28 code is a comm failure between the MCU and the CCU. First, check the wiring harnes connections to the MCU, the Motor, and the CCU. Make sure all the connections are tight and there ...

...of the ROS SOS (Y) signals exceeds the specified value. Procedure +5VDC is measured between the MCU PWB P/J401-B20 (+) and ground (-) Y N Replace the MCU PWB (PL 13.1). Check the wire between the ...