Questions & Answers for: ASUS parallel set in use Computers & Internet

...set the Parallel ATA IDE Controller to "Both" in the bios. If you could help, that would be wonderful. Try to check if there are some capacitor has been damage. Replace the capacitor in each specific ...

...parallel port. I know this solution is late, but maybe it could help. First, a couple easy things to try: Enter the BIOS and set to to the "Fail Safe Defaults", if possible. Save the BIOS changes and ...

...set the bios up properly". now, no matter what i do it will only show up as 667 mhz . I have updated my bios..............second problem my first video card was a geforce 7300 le by MSI. it worked ...

Set to this in bios). Parallel = P-ATA = IDE drive. Serial = S-ATA = SATA drive. Need the manual? Click on this Asus link; http://support.asus.com/download/download.aspx?modelname=P4P800S&SLanguage=en

set to [Enabled] Check the lights for proper operation. See page 1-23 in manual. If the, ACT/LINK is not flashing than the MB LAN controller is bad. LED Your MB is warranted for three years. Call Asus

FAULTY PARALLEL PORT ON ASUS P4P800-MX the parallel port on my asus p4p800-mx motherboard is not working. it does not see any device plugged to the parallel port. i tried using quicktech pro ...

...parallel peripherals you're hooking up. That's a jumper less board on an ATX setup format and all connections are in series as well as require firm connection click seating for the system to transfer ...

...set as the slave. The back side of each ROM drive is marked M for Master, S for Slave & C for cable select. (Cable Select not suggested). Double check the data cable. Remove and re-seat at the ...

...set of capacitors in parallel was faulty, just that one was. With a multiple layer motherboard it would be difficult or impossible to track down a fault through testing, or to repair it once it's ...

see set of parallel wire stuck in jack remove it and put it back on same slot be sure your tab is switched off I made a video on how to change the screen. The screen could be broke or a cable came out