Questions & Answers for: SIIG parallel set in use Computers & Internet

doesn't recognize new SATA disk. Have checked Doesn't recognize new SATA disk. Have checked that disk is goodand can be accessed with a USB controller. Also, the SATA card BIOS does come up but shows ...

I have bought an SIIG JJ-P00112-S2 single parallel port card and installed it on an ASUS P5Q motherboard which does not have a parallel port on it, thus in the BIOS there is no where to see setting ...

How to set up and use HP RF 2.4G Presenter ? T.K. balaji Press the receiver button until it flashing, then press the "right button mouse" on your transmitter for about 5 seconds. Both action should be

Hi, I can't find drivers for my siig PCI Cyber parallel drive. I tryed to install the drive on windows XP and on windows 7. The drive serial number is jj-p00112-b pls help!!! You will have to add this

parallel port card? I'm running Windows XP SP2, and the card is SIIG JJ-P00112. The card has no jumpers. The settings that I want to change are the address, 378 hex, and the LPT mode, SBB, and the IRQ

port forwarding Hi, I have set my IP adress as static and i had open the ports on the routeur but my p2p client says that it is not. What is the solution? Thanks Try to put your IP manually as defined

siig sc-sat212-s4, stops boot when connected If drives are disconnected from the card, the boot runs normally, and drives can be hot plugged and work fine. Any drive connected to the card at boot will