Questions & Answers for: pb 150

Can't remove rear rotor on 2001 F-150. Tried pounding, PB Blaster & propane torch, no luck. loosen off park brake. band on the inside of rotor

...150. Tried pounding, PB Blaster & propane torch, no luck. >loosen off park brake. band on the inside of rotor obviously park is off. i'm having the same problem, was hammering it a little all ...

...150 Van This is usually the control arm bushings it's a fairly expensive repair. You do not need to replace the bushings right away. You can spray the bushings with a good penetrating fluid like PB ...

...150 chips. After plugging everything back in just as it was, I turned the TV on and the image is a lot worse than before. Now the whole screen has a terrible red/blue double image. What do I do now? ...

...150 SUPER CAB HAS TWO GAS TANKS ON IT, THE FRONT TANK WILL NOT WORK WHEN I CHANGE FROM REAR TO FRONT, THE GAS GUAGE WILL READ BUT I CAN'T GET ANY GAS FROM THE TANK TO THE ENGINE. switch over valve ...

2005 Ford F 150 throws p2104 tac system forced idle code frequently.Need advice. Remove the throttle body and clean the carbon off the throttle plate being carefull not to harm any coating that may be

...150 truck Remove the bolts from the brackets. There is probably about 4 of them. Don't drop it on yourself ;) plenty of pb blaster ( rust penetrater) or torch. remove bolts at shock mount; 4 at the ...

150 miles last season on a tank. Any ideas as to why? If you did not prep the bike for long term storage , the gas in the carb has turned to varnish and the jets are glogged up. Take them apart, clean

...4 wheel drive will not work transfer case switch on driver side stake 3 10mm bolts out spray with pb blaster engage it while its out turn it off and on till it works. if u dont use them often they ...

...150,,300 six. the bottom bolt on the alternator snapped off during removal,now i cant get it off and cant get to the bracket bolts either,,,any ideas? Spray the bolt with PB Blaster a few times and ...