Questions & Answers for: procom pilot adjust

Pilot light seems to high The pilot light on my Ml300EHBC seems to run to high. It flickers and and has a very distinct pressure sound to it. FLickers mostly blue to a little orange and seems to be ...

...the pilot gets smaller and the heater won't light. The heater has ceramic tile and the flame will flicker over the tile but it acts as if it has air on it.. gas pressure to low adjust 9 to 11 ...

...will help further. If cleaning does not work you will need to replace the thermocouple or the ODS Pilot Assembley. You can contact Master Parts at 800-446-1446 and they carry part for ProCom. Thank ...

pilot keeps going out check thermocouple small copper sealed tube that flame burns against flame should be burning on tube when starting or as pilot lite,if has soot wipe with rag if adjustment good ...

Is the regulator you have rated under 1/2 pound pressure? Try to throttle down the shutoff on the tank to see if pilot gets better. If so, you have a pressure issue. Gas you adjust the pilot gas valve

...Procom MN300HPA ventless heater and the pilot will not light with well gas. Is there some type of converison necessary to get this unit to work or do I need to get a new unit. ProCom will not ...

...adjust the Thermocouple into the flame. But, you can clean the pilot assembly, so that the pilot flame doesn't curl (curve upward away from the thermocouple). Turn off the heater: Use canned ...

...adjust or change the thermocouple and dont know how to get it off follow the copper wire to the gas valve undo the silver nut  follow the thermocouple copper wire to the pilot undo the brass/ ...

pilot flame noisy and lifting on procom ml150tpa heater; how to adjust the flame The pilot flame is noisy and lifts off. We have cleaned the orifice & replaced the thermocouple. The LP gas pressure in

...ProCom Ventless products are equipped with an ODS pilot assembly, precision-engineered burners for clean burn and a non-adjustable regulator to prevent over-firing. The purpose of the ODS is to shut ...