...controller BIOS, once the cable SCSI cable is connected to HDDs, if cable is not connected, the BIOS can be configured through Ctrl+M combination. My board is an ASUS P4S800D-X, my hdds are seagate ...
raid config problem iam having PCBX518 -SB1 LSI logic SCSI adapter and it is having with four hard disc's . for RAID 05 configuration 3 of them making as a logical drive and one HOT SPARE, but when i ...
Question about Compaq ProLiant DL380 G4 Server
...SCSI Ultra160/320 Controller * Smart Array 641 PCI-X controller (3.06GHz models) * Smart Array 532 PCI array controller installed on Array models (older models) Compaq ProLiant ML350 Integrated Dual ...
Question about Compaq ProLiant ML530 Server
...for your server, press F10 at start-up. This should get you there to verify if settings are detecting SCSI devices. If they are there, you may have to reinstall the SCSI controller drivers. Good
SCSI RAID controller. You will need to get a separate SE SCSI HBA instead. These are pretty cheap, usually just over $100 list from HP. If you haven't attached anything new, then you should check your
...SCSI controller and O.S. (either 98SE and Windows XP pro) configure properly the peripheral, but diagnostic test reveals a hardware error, in fact the lamp is on, until scan begin, and, immediately ...
A boot message "SCSI bios A boot message "SCSI bios not installed" . pressing f1 continues and loads SERVER2003. How to get rid of message ? Disable the SCSI controller in the BIOS.
Question about Compaq ProLiant ML350 G3 Server
...controller if external SCSI drive is powered on. MY ProLiant 350 g3 tries to boot from my SCSI adapter if the SCSI drive is powered on. I need it to boot from the Smart Raid which it does if the SCSI ...
...record bot configuration. it then continues, initializes intel boot agent says press ctrl A for scsiselect utility. after that it says saving configuration whether I press something or not and ...
Question about Compaq ProLiant ML350 G3 Server
...change the boot device from the onboard SCSI controller to the IDE controller. It is very likely that you will have to disconnect all SCSI devices to boot to IDE, if it is possible. I hope this
Usually answered in minutes!
5,067 Questions
2,066 Questions
1,757 Questions
1,195 Questions
1,096 Questions
