Questions & Answers for: stapler head

...in the front portion of the stapler where it forms the staple and presses it into the stapler. You would most likely have to remove the stapler, and remove the binding staple from the stapler

...xerox ASF 100 stapler head Hi I am in need of a part number fot a Xerox ASF 100 stapler head 72K171 DO YOU KNOW WHERE TO BUY THIS AT GOOD PRICE? XEROX WANTED OVER 600, I AM LOOKING FOR A

...stapler and try manually pushing up on the staple head to see if you can get the driver blade to come down. Does it come down smoothly, or does it seem like there is something stuck in there? If you ...

...stapler head has become jammed with loose staples or the motor inside it has worn out.. also the stapler cable that controls it between the finisher controller and the stapler head has been damaged ...

...shoot 1 1/2" to 2" staples right out of the box. If your stapler won't feed 2" staples, check the magazine all the way up to the power head for any foreign material that may hold up your

...staples from the magazine. Then, unravel one end of a paperclip and attempt to remove the jammed staple from the head of the stapler. ...

against the staples... should be pointed tips down. Put the stapler on a firm surface and press it as you would when stapling something. The two parts of the stapler head will join back together again

...These do not load into stapler magazine. T50 flat head staples are too wide to fit. Any recommendations? Need flat head staples for chair recovery work. try T 20 Flat crown with 5/16-inch ...

...It is jammed,a stapler is stuck in there.Open up magazine cover and pull out staples,then look and see staple that is jammed,use a flat head screw driver or needle nose pliers to pull staple

...stapler head, the spring, and the pusher rod. Insert the spring into the stapler body. Slide the magazine tray over the spring until it clicks into place. Place the pusher rod over the spring and ...