Questions & Answers for: Sharp true or false Heating & Cooling

sharp al 1655 false paper jam message, hi, all you fellow techs. I have a sharp al 1655 false paper jam. I went into diagnostic to test the three sensors in the paper path. I have checked to see if ...

...true and 3 is false, You need to remove the platen glass (the big glass) an clean the mirrors. WITH THE POWER OFF If all are TRUE you have an issue inside the Photo conductor unit and it will need to ...

what is the nean h or 4? Fusing Unit failure to heat. Usually a false code. Here is how to reset this code. Press "Clear" then "Exposure Mode" then "Clear" then "Exposure Mode" quickly like within 4 ...

Error code H4 on Sharp AL-1641CS? Error code H4? Usually a flase code on these models. Try clearing by pressing "C" then far left key (Exposure Mode) then "C" then far left again. Must be pressed ...

false code meaning there is really no problem. This is true in about 75% of cases. I have a tip posted here on fixya to help people with this problem. I have listed the link here for your convenience.

grinding noise during warm up. Tells my theres no paper but there is That is the fuser drive gear. It wears out and needs to be replaced. That causes a vibration and will cause your low paper message ...

I get a code that shows 4H and I do not know what it is. Thanks for the help H4 is most commonly a false code. Here is the reset procedure: Press "C" then the far left key (exposure mode) then the "C"

How do I clear a H-4 code on a Sharp al 2040cs? It is the fuser, but sometimes it is just a false code. to reset enter buttons clr, exposure, clr, exposure, the display will blank, enter 14, press ...

false paper jam message That is your exact model? try to remove the cartridge and check if there is some paper underneath it. Also try to open and close the cardridge tray with the printer powered on.

I want Flash code for Sharp Al 1216 photocopier H4 error appears Purportedly, H4 refers to heat lamp problems, either broken heat lamp or dirty thermostat on the heater roller assembly. It may be ...