Questions & Answers for: xp2 pumps

i am trying to find a replacement for ann XP2 i am trying to find a replacement for an XP2 pump wet end. . everywhere online says it has a 2 inch input and output, but when i measured it, it measures ...

...the wet-end(pump) apart to replace them. Take note of motor shaft size. Gecko/AquaFlo Flowmaster XP2 has 5/8" shaft.Get some here, or use the shaft seal guide on that same

2006 flo-master xp2 pump failed. need to buy a replacement. mine is 230 volts. I have seen replacements online that are 240 volts. will this work for me? Thank you Dan Yes, either rating is really ...

I am looking for a Flo-Master XP2 by Aqua Flo. Modal 06630397-2. How much would it be? A quick google search brings up a number of online sites between $340, and $430

I was told that the Aqua Flo Master Xp2 Spa pump 1.5 hp 2 speed pump was the equivalent to the Sta rite Max E Pro 2 speed pump but then from another source was told that the Aqua Flo was not made for ...

I am putting a new seal and impeller on my xp2 2.5 hp pump and am wondering if I should use a bit of lithium grease when installing the seal or leave it dry? Thanks in advance. NO GREASE! Use a little

Fol-Master xp2 Model #06620776-2 making noise. Still pumps water. The pump is making a growling noise. It still pumps the water. bad motor b replace

2009 flo master xp2 pump hums loudly when running 06625770-2 2 speed bad motor bearings replace whole pump

Hi,i have an aquaflow xp2 flowmaster pump 2 speed.it runs on low speed but wont run on high speed capacitors have been checked and all good does anyone have any ideas ? you need a 2 speed relay

I just bought and installed a Balboa VS501Z watergroup I have a FloMaster XP2 2 speed pump ,original equipment,and cannot get high speed to work any ideas?I also am using the controller that came with